MR Dental Heat Cure Liquid (Monomer)

Brand : MR Dental

MR Dental Heat Cure Liquid

Contents: 1 Jar
Net Weight :
Gross Weight :

Instruction For Use:-

1. Dispense approximately 5 or 10ml Heat Cure Liquid into a mixing vessel and sprinkle Heatcure Powder onto the Liquid over a period of 30/40 seconds. Tap gently 2/3 times on the side of the mixing pot and remove any excess powder by inverting the vessel, then spatulate for 45-60 seconds.
   
2. If standard measuring equipment available, then use 23.4gm Powder : 10ml Liquid ratio or use 3.5 part volume of Powder : 1 part volume of Meadway Universal HeatCure Liquid
3. The material will dough in 15 (±3 minutes) at 23℃

Packing of Material
Pack the dough material into the mould and cover with a polythene sheet. Replace the flask lid and apply pressure slowly under the bench press. Open the flask, remove polythene sheet, also remove or cut away the excess flask material around the mould with a sharp instrument.
Replace the flask lid and close completely under the bench press again, then transfer to a security flask clamp prior to curing. To achieve an optimum result, the temperature of the flask, when packed, should be between 20℃ - 30℃

Curing the material
Immerse the clamped flask (s) in cold, warm or boiling water and bring slowly to boil, not quicker than 7-10 minutes, and boil for 20 minutes. It is absolutely essential to ensure that the flask(s) should be fully covered by at least 5-7cms of water.
An extra thicker section can be cured by the following method. Immerse the clamped flask(s) into boiling water and turn off the source of heat supplied for 20 minutes, then reheat and bring water slowly to boil for further 20 minutes.

Manufactured in England by
MR. Dental Supplies Limited
4, Manor Way, Old Woking
Surrey, GU22 9JX, England
Tel: +44(0) 1483 773282
E-mail : info@mrdental.co.uk
Website : www.mrdental.co.uk